Just buy a MCC 003 8X DVD+R,here's the result.Please take a look the result and give some comment whether it's good or bad.
Your help is appreciated,thank you.

awesome results:)
The limits definned by the dvd standard are PIE<280, PIF<4 and PO=0. Also you might test at 2x reading speed. It produces the most accurate results.

(in reply to warez)

Yeap, supposed to be good.

However this kind of measurement can only be used to compare your own burns, otherwise the results are not safe.

(in reply to Blackbird)

Results are very good, as was expected from the BenQ DW1620A

(in reply to Iggy)

Just flash my firmware from S9 to T9,below it's the result.Using same media (MCC003 burn with 8X speed).Please take a look and compare with S9 firmware see whether it better than S9.
Thank you.

(in reply to emperor)

S9 result looks nicer i must say, but it could be media specific issue

(in reply to warez)

But many people say S9 already disable WOPC and it's only great for lousy media,so i flash it to T9 let it enable WOPC for better quality burning and i'm also didn't use the lousy media.How we see S9 is better than T9 from above test result?
Thank for answer.

(in reply to emperor)

Your T9 burn is better (in terms of total PIF as well as in terms of total and max. PIE).

Don't be fooled by the higher max. PIF of your T9 burn ... Nero CD Speed scans over an 8ECC interval for both PIE and PIF ... the specs state that PIF should be measured over 1 ECC (that's what the limit of 4 refers to).

As emperor stated ... the differences are most likely variations in media and/or burning conditions.

(in reply to warez)