Dimitris32
Posts: 103
Joined: 1/28/2005 Status: offline
|
Hello, although I 've built & upgraded several systems, I have never so far had the opportunity to work with SATA hard drives. Do these require a special setup routine during Windows XP Pro SP2 installation in newly built systems? I was reading on a website some time that someone had to copy some drivers from the Windows XP CD, boot with a bootable floppy, install them, and then, after restart, start the normal Windows installation. Is this correct, and if so, does it apply to all boards? Is there not a faster way (e.g., installing them the way IDE drives are installed, connect the cables and off you go)? :) Regards, Dimitris
< Message edited by Dimitris32 -- 11/17/2005 12:05:56 PM >
|