i just wanted to flash back the ls17.bin to my cdrw (formerly 0841)..
flash process
(winXP, winME bootdisk: pure dos using original ls17.bin
with pflash,etc. found on cdrinfo)
looked fine, but the counter went to 0 and showed some weird message.
tried flashing again, the flash app showed:
try to recover the drive with atapi soft reset
the status port is 0xff80 or something four times.
AFTER THAT: error in atapi command
inquiry + atapisoftreset fail

i assumed my cdrw was dead AND I WAS DAMN RIGHT.

i already tried turning off dma and jumper trick (UNFORTUNATELLY BIOS DOES NOT RECOGNIZE DRIVE):
"try to recover the drive with atapi soft reset
the status port is 0xff80 or something four times.
AFTER THAT: error in atapi command
inquiry + atapisoftreset fail" AGAIN.
DOES THIS REMIND ANYONE OF HIS PROBLEM?

is there something else i can do? i read something about flashing ls38.bin, but i already tried this (same message), this is not the problem here, it has to be some other type of problem.

ANY SUGESTIONS ARE WELCOME:::::::

Edited by - kayjay on 05/22/2002 09:04:53

Edited by - kayjay on 05/22/2002 10:37:54

i just tried to upgrade mine to the 12x version and got that same message. My drive does not appear to be dead though.

(in reply to kayjay)