RE: BTC 4816IM to 5224IM??? (Full Version)

All Forums >> [Optical Storage] >> Firmware

Message

---

john -> RE: BTC 4816IM to 5224IM??? (2/13/2003 5:43:10 PM) You would need a .BIN version and MTKFlash under DOS to recover your drive i think

---

Thund3rman -> RE: BTC 4816IM to 5224IM??? (2/13/2003 6:08:55 PM) I already posted this at another thread, but can you get me the bin I need? Can anyone get me the bin for BTC4816IM??

---

dhc014 -> RE: BTC 4816IM to 5224IM??? (2/14/2003 12:08:52 AM) You could be able to use the hex file that is extracted to a temporary directory when you run the official flasher from www.btcusa.com along with mtkWinFlash to flash your drive.

---

Thund3rman -> RE: BTC 4816IM to 5224IM??? (2/14/2003 5:55:48 PM) I already tryed mtkflash and mtkwinflash... No results... Mtkwinflash doesn't even see the drive... I thing i'm going to ask btc guys to put the firmware in again... Not even the open button works anymore... ;(

---

digi -> RE: BTC 4816IM to 5224IM??? (2/16/2003 2:22:31 AM) Try the new MtkWinFlash Direct IDE Port Mode. You'll find it (temporary) linked at the bottom of my MtkWinflash page: http://digi.rpc1.org/mwf.htm

---

Michael Lee -> RE: BTC 4816IM to 5224IM??? (2/17/2003 8:31:39 AM) In digi's web page, there is a Direct Port Mode to flash dead drive. Give it a try! http://digi.firmware-flash.com/mwf.htm Good Luck!

---

Page: <<   < prev  1 [2]

Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI

0