What is the threshold for PI/PO tests with DVDInfoPro (Full Version)

All Forums >> [Optical Storage Software] >> DVDInfoPro



Message

jbelder -> What is the threshold for PI/PO tests with DVDInfoPro (7/22/2005 7:33:56 AM)

Hi guys, Can you tell me what the ma is for a good burn with DVDInfoPro I saw some where it was 280/75 280 max on PI and 75 max on PO which scale is the most important? Any help would be appreciated Thanks



zebra -> RE: What is the threshold for PI/PO tests with DVDInfoPro (7/22/2005 10:51:38 PM)

It actually depends on the drive you use. ;)

If your scanning back with LiteOn, BenQ or NEC hardware, the tolerances are as follows:

*For parity inner measurement (PI), your scans should be <=280 in scale
*For parity outer measurement (PO), your scans should be <=32 in scale

However, this changes, if your using a Pioneer based drive to report back partiy information....

*For parity inner measurement (PI), your scans should be <=280 in scale
*For parity outer measurement (PO), your scans should be <=280 in scale

Hope it helps!




jbelder -> RE: What is the threshold for PI/PO tests with DVDInfoPro (7/24/2005 9:49:51 AM)

Thank You It does Jim   
quote:

ORIGINAL: zebra

It actually depends on the drive you use. ;)

If your scanning back with LiteOn, BenQ or NEC hardware, the tolerances are as follows:

*For parity inner measurement (PI), your scans should be <=280 in scale
*For parity outer measurement (PO), your scans should be <=32 in scale

However, this changes, if your using a Pioneer based drive to report back partiy information....

*For parity inner measurement (PI), your scans should be <=280 in scale
*For parity outer measurement (PO), your scans should be <=280 in scale

Hope it helps!





Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.015625