zebra
Posts: 225
Joined: 6/20/2004 From: .:Australia:. Status: offline
|
It actually depends on the drive you use. ;) If your scanning back with LiteOn, BenQ or NEC hardware, the tolerances are as follows: *For parity inner measurement (PI), your scans should be <=280 in scale *For parity outer measurement (PO), your scans should be <=32 in scale However, this changes, if your using a Pioneer based drive to report back partiy information.... *For parity inner measurement (PI), your scans should be <=280 in scale *For parity outer measurement (PO), your scans should be <=280 in scale Hope it helps!
_____________________________
Glory may be fleeting, but obscurity is forever My home - Speedlabs.org The Zebra BLOG!
|