Thursday, May 26, 2016
Search
  
Most Popular
Guides
General Computing
WEB Reviews
Seagate Enterprise Capacity 3.5 V.3 4TB SAS 6Gb/s HDD Review
OCZ Vector 256GB SSD Review @ Custom PC Review
Gigabyte F2A85XM-D3H
NZXT Phantom 630
Auvio Bluetooth Portable Speaker Review
Corsair H90 CPU Cooler Review
BIOSTAR Hi-Fi Z77X (Intel Z77) Motherboard Review
Noctua NH-L9i Cooler Review on Technic3D
Breaking News
ZTE's Axon 7 Smartphone Combines Impressive Specs With A Budget Price
Samsung To Expand Its Quantum-dort Expertise Sensors, Batteries And New TVs
Lenovo Reports Full-year loss On Low PC And Motorola Phones
TSMC to Boost R&D Spending To Accelerate Development Of More Advanced Chips
Sony Playstation 4 Sales Surpass 40 Million Units
SEC is Investigating Alibaba's Accounting Practices
HP Announces Omen Portfolio Of Gaming PCs
New Toshiba 8TB X300 Hard Disk Drive Released
Home > Guides > General Computing

Saturday, January 26, 2002
Installation of SCSI HD

2. Power Tips

Installing a SCSI HD - Page 2

Source: Maxtor

- SCSI Termination Power

To ensure that there is a sufficient level of power along the entire SCSI bus, we recommend that all devices on the SCSI bus supply Termination Power (if they are capable). SCSI devices are protected by a diode or similar semiconductor, to prevent back flow of the terminator power when more than one device supplies this power. Configure the drive to provide Termination Power by installing a jumper across the appropriate connector on the Secondary Option Connector located on the front of the drive. Most drives intended for File Servers have features of minimal value in a PC configuration. For the most part, these minimal use features are disabled by default. These options include Spin Delay, Force Narrow mode, and others. They can typically be ignored. It is important to confirm whether a function is enabled or disabled. That is, it needs a jumper in place, or off, before proceeding further.

- Power Cable

Power cables must be connected correctly and securely. The System power supply must be rated to accept today's 7,200 and 10,000 RPM drives. Spin up /down errors may result. See your system manufacturer to confirm the power source is rated for today's high speed drives. To insure proper connection the power cable connector is keyed so that the connector can only fit onto the drive's four power pins correctly. After you insure pin alignment, firmly push the cable into place.

power1a.gif - 49845 Bytes




Get RSS feed Easy Print E-Mail this Message


 
Home | News | All News | Reviews | Articles | Guides | Download | Expert Area | Forum | Site Info
Site best viewed at 1024x768+ - CDRINFO.COM 1998-2016 - All rights reserved -
Privacy policy - Contact Us .