Friday, October 24, 2014
Search
  
Most Popular
Hardware Reviews
PC Parts
Crucial MX100 512GB SSD review
Samsung 850 Pro SSD review
Toshiba SSHD 1TB review
Micron M600 128GB SSD review
WEB Reviews
Seagate Enterprise Capacity 3.5 V.3 4TB SAS 6Gb/s HDD Review
OCZ Vector 256GB SSD Review @ Custom PC Review
Gigabyte F2A85XM-D3H
NZXT Phantom 630
Auvio Bluetooth Portable Speaker Review
Corsair H90 CPU Cooler Review
BIOSTAR Hi-Fi Z77X (Intel Z77) Motherboard Review
Noctua NH-L9i Cooler Review on Technic3D
Breaking News
FCC Says Airwave Auction To Delay Until 2016
HP Broadens Moonshot Portfolio With Intel-powered Models
Microsoft To Keep Nokia Brand For Low-end Smartphones
LG Introduces Its First Octa-Core Application Processor
Cloud and Surface 3 Drive Microsoft's Revenue
Micron Urges Investors To Reject TRC Capital's Unsolicited Tender Offer
Facebook Returns To Chat Roots With Rooms App
Sony SmartWatch 3 And LG G Watch R Are Rolling Out With Updated Android Wear Software
Home > Hardware Reviews > PC Parts

Thursday, April 19, 2007
Vantec iCEBERQ6

4. Installation - 2

With the VGA cooler lying face down, place the VGA card face down onto cooler, allowing the mounting screws to pass through the card's mounting hole. Be careful with this step!

Next, place an insulation spacer on each mounting screw

Attach a spring nut to each mounting screw and fasten with a screwdriver. Give each spring nut a few turns until it is secure:

Our air cooled MSI 7600 GT is ready to roll! Note that now our card is double the width and will take up an extra backplane slot.

The copper core has enough distance between it and the surrounding components, not to cause any damage:

The time has come to install your card. There shouldn't be any problems here, just find two adjacent backplane slots and make sure that the card wont interfere with any nearby chipsets that could prevent the card from being installed correct. In our case (Asus P5B Deluxe), there is a capacitor close by, so we had to be careful when installing or removing the VGA card:

As we mentioned earlier, you need at least two empty backplane slots for the VGA card and the iCEBERQ 6 cooler.The photo below shows the setup at the rear of the case. Note the ventilation holes of the iCEBERQ 6, which blows hot air out of the case.

A panoramic view of the the MSI 7600GT cooled with Vantec's iCEbErQ6. As a last minute tip, don't forget to plug-in the cooler's power connector to a 3-pin fan header:




Get RSS feed Easy Print E-Mail this Message


 
Home | News | All News | Reviews | Articles | Guides | Download | Expert Area | Forum | Site Info
Site best viewed at 1024x768+ - CDRINFO.COM 1998-2014 - All rights reserved -
Privacy policy - Contact Us .