Hi there, I have the drive and I tried to update it's firmware from 1.01 to 1.04 under Windows XP (with a Dos boot disk).
I typed at the prompt: je3 je3lg409.hex <enter>
and it scanned my IDE channels and found my recorder. The first stage complete at 100%, BUT!! when in went onto the second stage (writing to OUTPUT FILE), it stopped at 44% and it simply said, "Could not write output file". This worried me. I tired it again and same thing happened.
I went under NERO (126.96.36.199) and check the firmware and it displayed 1.04. I was a little suspicious of this.
Has anyone tried the firmware update and ended up with the same results?
Is the 'output file' an important process in the firmware updating that i should worry about if it did not complete? (I have a feeling that output file is the file being sent to the recorder's bios).
LG 32x10x40 (GCE-8320B)